How Much Does Sprinkler Repair Cost in Denton, TX?

What a head or a valve repair costs

A single sprinkler head that is spraying wrong, sunk or broken runs $65 to $90. That covers the head and the labor to dig it out and swap it.

Valve repair or replacement runs $75 to $300. The spread is wide because a valve job can be a quick fix or a full replacement, and we can't tell which until the valve is open. A valve buried under shrubbery or a deck also takes longer to reach than one in open lawn, and that time goes into the price.

If the ground is open and we turn up a cracked fitting or a bad wire splice, you hear about it from us before it goes on the job.

How we diagnose a zone that won't run

When a zone fails to come on, we don't start by digging. We check the controller output first, then the wire connections, then the solenoid. Plenty of dead zones turn out to be a loose connection or a failed solenoid, which is a much smaller job than a new valve.

If the problem is the valve itself, we shut off its water supply, open it up and look at the diaphragm for debris or damage. A diaphragm that only needs cleaning is a short visit, priced near the bottom of the valve range. A damaged diaphragm gets replaced, and a valve that is too far gone gets swapped out, which is where the price climbs toward $300.

Older systems and repeat repairs

The median home in Denton was built around 1995, so many of the systems we work on have been running for decades. Diaphragms wear, solenoids weaken and controllers age. When the same valve or zone has needed work a few springs in a row, we say so and price replacing it, so you aren't paying for the same visit year after year.

If your controller is the failing part, we replace it as its own line item on the quote, separate from the valve and head work.

Hail damage and flood corridors

Hail in the Denton area has been big enough to damage thousands of homes, and a cracked controller housing or a damaged exposed component is easy to miss from the driveway. We check these on a repair visit if the system has been through a bad storm.

If your lot sits along Cooper Creek, Pecan Creek, North Pecan Creek, Hickory Creek, Dry Fork Hickory Creek or one of their tributaries, we check the flood map before we trench or place equipment. That can change where we put a valve box or run a new line, and it is better to settle it before we dig than after.

What to do next

Our written quote lists what we found, what we'll fix and what it costs, so you can see where a valve job landed in the $75 to $300 range.